When It Is Time to Replace Your Heater’s Thermostat

Just like any other equipment, your heater will eventually wear out. One of the components that may go first is the thermostat. The thermostat is responsible for distributing a steady heat to the entire room. If it malfunctions, you may either have an extreme hot room or a cold one. When this happens, the Heating Repair Little Fall NJ specialist is available to fix the thermostat for you. However, when repair options are not possible, the next step is to have it replaced. You can actually do the replacement yourself but it is ideal to seek the services of the heating repair contractors. If you live somewhere in Heating Repair Little Falls NJ, the best contractor is the Aircool Mechanical. Here are the steps of replacing thermostat if you ever need to do it by yourself: 1. Prepare your tools. You want to have the right tools for your replacing needs. Basically, you only need a level, screwdriver and a tape. Of course, never ever forget to buy a replacement thermostat. Now, remember that the thermostat to be replaced needs to be compatible with the heater. There are old parts that cannot be found on the market anymore but there is always a compatible alternative for it. To make sure that your thermostat is compatible with your brand and model, seek the help of the experts. 2. Actual removal. Once you complete all you need, you are now ready to take off the thermostat. To do this, pull away the faceplate and locate where the screws are. Using your tools, remove each screw as you see the wires of the heater. 3. Disconnecting wires. You can already see the wires once you get rid of all the screws. Before you can disconnect the wires, make sure that you remember where these are connected so you will not have to second guess. Some people take pictures of the actual wires so they can easily install their new thermostat. If the wires are dirty, gently scrape the dirt off by using a utility knife. 4. Connecting wires. Carefully connect all the wires in the new thermostat. This is done by means of using a tape. It is ideal to tape the opening efficiently so no cold air to affect the thermostat. 5. Mounting back the screws. Connect the screws as tightly as you can. There are thermostats that have a mercury tube installed – make sure that it is leveled out as you place the thermostat in its proper place. 6. Last step. Finally, put back the faceplate and check if your new thermostat is actually working. To do this, simply turn on the heater and see if it set at your desired temperature. You can also use a thermometer and stick it on the wall, a few inches away from the thermostat. This should test if the actual temperature shown on the thermostat is what it actually emits. These are the ways on how to replace your thermostat.